Revox B77 MkII

Myyty

Revox B77 MkII

ei sis. ALV

Varasto loppu

Erittäin hieno

Specifications:
*Tape transport mechanism: 3 motor tape drive; 2 AC driven spooling motors; 1 AC driven capstan motor, electronically regulated
*Tape speeds: 3.75 ips and 7.5 ips, electronic change-over, tolerance from nominal +-0.2%
*Wow and flutter: (as per DIN 45507) At 3.75 ips <0.1%, at 7.5 ips <0.08%
*Tape slip: Maximum 0.2%
*Reel size: Up to 10.5” diameter (minimum hub diameter 2.36”). Tape tension switchable for small hub diameters
*Winding time: Approximately 135 seconds for 3,600 ft of tape
*Tape transport control: Integrated control logic with tape motion sensor provides
for any desired transition between different operating modes. Contactless electronic
switching of all motors. Remote control of all transport functions and electronic timer operation are possible
*Equalization: (as per NAB) 3.75 ips: 90 microsec/3180 microsec, 7.5 ips: 50 microsec/3180 microsec
*Frequency response: (measured via tape at -20 VU) 3.75 ips 30Hz…..16kHz +2/-3dB, 50Hz…..10kHz +-1.5dB
7.5 ips 30Hz…..20kHz +2/-3dB 50Hz…..15kHz +-1.5dB
*Peak recording level: 514 nWb/m corresponds to 6dB above 0VU
*Level metering: VU meter as per ASA standard, with LED peak level indicators
*Distortion: 3.75 ips at 0VU <1%, at 0VU+6dB <2.5% 7.5 ips at 0VU <0.6%, at 0VU+6dB <1.5%
*Signal to noise ratio: (weighted as per ASA-A) Half track 3.75 ips >64dB,
7.5 ips >67dB, Quarter track 3.75 ips >60dB, 7.5 ips >63dB
*Crosstalk: At 1kHz stereo >45dB, mono >60dB
*Erase depth: At 7.5 ips >75dB
*Inputs per channel: MIC LO 0.15mV/2k2ohms for low impedance microphones. MIC HI 2.8mV/110kohms for high impedance microphones. RADIO 2.8mV/20kohms. AUX 40mV/220kohms
*Outputs per channel: (Level at 6dB above 0VU). OUTPUT 1.55V/390ohms adjustable with preset. RADIO 1.55V/4k7ohms adjustable with preset
PHONES 5.6V/220ohms adjustable with control
*Connectors for: Remote control of tape transport, Remote control of variable tape speed, Slide projector or crossfade unit (electronics optional)
*Components: 11 ICs, 1 opto-coupler, 4 triacs, 60 transistors, 33 diodes, 5 LEDs, 2 full wave rectifiers, 3 relays
*Voltage selector for 100V, 120V, 140V, 200V, 220V, 240V, 50…..60Hz without conversion, maximum power 80 watts
*Weight: Approximately 17kg
*Dimensions: 452 x 414 x 207 mm (W x H x D)
*Clearance required for 10.5” reels height 464mm, width 538mm

Mk II 
*Compared with the preceeding MK I model, the MKII offers the following additional facilities: 
*Built-in variable tape speed 
*Cueing position with open head shield

3-moottorinen 2-raitainen dekkimalli (vaatii vahvistimen).

Perusteellisesti huollettu juuri; laskurin hihnat, painotela vaihdettu ja mittarin lamppu uusittu. Puhdistus, huollot, voitelut, säädöt, tarkastukset. Mitattu äänitys-/toistokäyrä. Tarkastus, koekäyttö. Huollon on tehnyt nauhureihin erikoistunut huoltoliike. Tarkka selvitys tehdyistä töistä dokumentoitu.

Alkuperäiset Revox Nab-keskiöt kuuluvat hintaan.

2 kpl alumiinisia nauhakeloja (Revox ja Fostex + 2 kpl Revox koteloita) myydään erikseen. Hinta 80€.

Mahdollisuus ostaa alkuperäinen langallinen kaukosäädin kelanauhurikaupan yhteydessä hintaan 130€. (Erikseen ostettuna 160€).

 

Ota yhteyttä tästä tuotteesta

* merkatut kentät ovat pakollisia.

Sivun alkuun